Assembly - Pinnacle Master MH-18-PCH-A Manual De Usuario E Instrucciones De Funcionamiento

1. Place heater base on flat surface with wheels
on the ground.
2. Line up holes in bottom of heater cabinet with
locking tabs on top of base (see Figure 1)
3. Mount heater cabinet to heater base, sliding
tabs through holes in bottom of cabinet and
sliding cabinet backward approximately 1/4" or
until cabinet will not move further back.
4. Use thumbscrews to attach heater cabinet to
heater base.
5. Inspect heater closely for any damage that
may have occured during shipping. If there
is any damage, return the heater to place of
purchase.
CAUTION
assembly supplied with the heater must be used
without alteration.
Figure 1
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, CONNECTED
TO A POWER SOURCE, OR WHILE CONNECTED TO A FUEL SOURCE.

ASSEMBLY

The Propane (LP)
gas pressure
regulator and hose
Connecting to Gas Supply
IMPORTANT! - Always use a propane (LP)
cylinder that has a connection device compatible
with the hose and regulator assembly supplied.
1. Remove the back cover by sliding the cover
straight up and away from the heater body.
Place the LP cylinder on the bottom plate and
replace the back cover.
2. To connect LP cylinder, insert regulator end
fitting into cylinder valve, rotate coupling nut
clockwise and tighten firmly (see Figure 2)
3. Open valve on propane cylinder slowly. If the
valve is not opened slowly, the excess flow
check valve in the regulator will stop the flow
of gas. If this should happen, close the valve,
wait one minute (or until you hear the valve
click), and re-open, slowly.
4. Be sure to inspect all connections for leaks, by
using a 50/50 mixture of dish soap and water
on all connection. Any bubbles forming indi-
cate a leak.
CAUTION
If the hose is cut or frayed, replace it with the
manufacturer suggested assembly.
Figure 2
6
Be sure to inspect
the regulator hose
before each use.
Cabinet Heater User's Manual