Test Firing Heater; Moving And Positioning The Heater; Ventilation - Pinnacle Master MH-18-PCH-A Manual De Usuario E Instrucciones De Funcionamiento

Test Firing Heater:

It is always a good idea to test fire your heater
in a safe and controlled environment, in an area
with adequate ventilation, and away from any
combustibles to be sure that all functions of the
heater and gas supply system are operating
properly.
Leak test all gas connections with a 50/50 solution
of dish soap and water. DO NOT use a flame to test
for leaks!

Moving and Positioning the Heater:

There is a brake in each of the front wheels of your
heater that helps keep it in place when in use. To
engage the brakes, push the lever down on each
wheel. To move the heater, release the brakes,
simply by flipping the levers on both brakes up.
DANGER
– Risk of indoor air pollution and Carbon
Monoxide Poisoning. Use heater only in well
ventilated areas.
– Refer to Safety Information on pages 2-3
for information about Carbon Monoxide
Poisoning.
– ALWAYS provide a fresh air opening in the
heated space of at least 3 square feet (2,800
sq. cm) for each 100,000 BTU / Hr. of heater
output. Provide a larger opening if more
heaters are being used.
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, CONNECTED
TO A POWER SOURCE, OR WHILE CONNECTED TO A FUEL SOURCE.
OPERATION (CONT.)
CARBON MONOXIDE POISONING MAY LEAD TO DEATH!

VENTILATION

– FOR OUTDOOR USE. INDOOR USE
PERMITTED ONLY FOR: The temporary
heating of adequately ventilated buildings or
structures under construction, alteration or
repair.
Minimum Ventilation Opening Needed
DANGER
non-adequately ventilated enclosed spaces.
9
MH-18-PCH-A
0.54 ft.
2
501.7 cm
2
Not for use in
residential living
areas or in
Cabinet Heater User's Manual