Fire Sense 1031510 Manual De Instrucciones página 9

ASSEMBLY
9
While supporting heater, tilt the Head Assembly
and slide 3 Large Flat Washers
Studs W
and slide 3 Large Flat Washers over the
onto the
Once you have tightened the Wing Nuts, return the heater
to an upright position.
Hardware Used: 6x Large Flat Washer
10
Connect the hose and regulator to the LP cylinder.
The LP cylinder is sold separately. Use a standard
9.07 kg / 20 lb propane cylinder only. Lift the Tank Housing
up and rest it on the top of the assembled Post Supports
Screw Regulator H onto Gas Hose
Hand tighten securely then tighten with the Wrench. Attach
the Regulator to the valve on the LP cylinder and hand tighten
securely. Place LP tank onto base of heater. Secure the
LPG tank by attaching the Chain
Lower the Tank Housing.
NOTE: Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for storage and
Contact us for assistance: (866) 985-7877 | www.wtliving.com
R over the
. Secure with 3 Wing Nuts.
B
3x Wing Nut V
E . Do not cross thread.
onto the post supports.
L
C
and
D
I .
9