Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
PREPARING FOR OPERATION
1.
Check the heater for possible shipping damage. If any is
found, immediately notify the factory.
2.
Follow all of the "Precautions".
3.
Assemble the regulator to the heater fuel inlet with the gas
flow arrow pointed toward the heater. You should use a pipe
sealant onto the male pipr thread, since this will insure that
no sealant gets into the fuel system. Then screw the male
thread into the inlet and tighten by rotating clockwise.
4.
Connect the hose to the heater by rotating the hose fitting
clockwise.
5.
Securely tighten all gas connections.
6.
Open the natural gas valve and check all gas connections
with a soap and water solution. DO NOT USE A FLAME.
7.
Connect power cord to well-grounded 115V, 60 Hz, 1Ø source
of power.
8.
When using an extension cord, make certain that it is a
3-wire (grounded) cord of proper wire size.
START
1.
Slowly open the main valve at propane cylinder to prevent
excess flow check valve from closing.
2.
Set thermostat to full on. Heater will ignite automatically.
3.
Adjust ball valve on control panel to desired burn rate.
4.
Set thermostat to desired temperature. Heater will turn off
and on automatically as the temperature varies in the heater
area.
STOP
1.
Securely close valve on the propane cylinder.
2.
Continue to operate heater until all fuel in the hose has
burned.
3.
Turn the heater thermostat to "off". For extended shut down
or in areas where the temperature is below 0°F, unplug the
heater.
RESTART AFTER SAFETY SHUTDOWN
1.
Securely close valve at propane cylinder. Unplug heater.
2.
Wait 5 minutes.
3.
Restart following "Start" procedure.
MAINTENANCE AND STORAGE
1.
The heater should be inspected before each use, and at least
annually by a qualified person.
2.
Turn off the natural gas supply valve when the heater is not
in use.
Force-Air Propane Construction Heater
SERVICING
A hazardous condition may result if a heater is used that has
been modified or is not functioning properly.
When the heater is working properly:
•
The flame is contained within the heater.
•
The flame is essentially blue with perhaps some
yellow tipping.
•
There is no strong disagreeable odor, eye burning or
other physical discomfort.
•
There is no smoke or soot internal or external to the
heater.
•
There are no unplanned or unexplained shut downs
of the heater.
The parts lists and wiring diagram show the heater as it was
constructed. Do not use a heater which is different from
that shown. In this regard, use only the regulator supplied
with the heater. IMPORTANT Match the color stripe on the
hangtag attached to the hose assembly with the color on the
label located near the propane inlet fitting on the heater. Do
not use alternates. For this heater, the regulator must be set
as shown in "specifications". If there is any uncertainty about
the regulator setting, have it checked.
A heater which is not working right must be repaired, but
only by a trained, experienced service person.
In-warranty products will be repaired with no charge for
either parts or labor. Please include a brief statement
indicating date, place of purchase, the nature of the problem
and proof of purchase.
Out-of-warrranty products will be repaired with a charge for
parts and labor.
5
Operating Instructions and Owner's Manual
Publicidad
Capítulos
Tabla de contenido
