Part 2. Preparation; Supplied Items; Interconnections - Sony SDX-D700C Guía Del Operador

Part 2. Preparation

Supplied Items

Interconnections

After you confirm that you have all of the required accessories for your
installation, connect the drive to the host computer, and select the SCSI ID
with the rotary switch on the rear panel.
When you first open the box, make sure it contains the following items.
Contact your supplier if anything is missing or broken.
• AIT Drive Unit
• Power Cable
• Operator's Guide
The SCSI bus allows connection of up to fifteen peripherals to the host
computer. Use a SCSI cable with a half pitch 68 pin connector.
Precautions
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
a SCSI bus terminator to the open connector.
• The total length of the SCSI cable(s) between the host computer and the last
device should be less than 12 meters.
AC power
*1
It should be less than 1.5 meters, if connected to single-ended SCSI host adaptor.
*1
Figure 2-1 Interconnections
11
Part 2. Preparation