Part 3. Operation; How To Use The Ait Drive - Sony SDX-D700C Guía Del Operador

Part 3. Operation

How to use the AIT Drive

14
Part 3. Operation
This section describes how to use the AIT drive, and how to handle data
cartridges.
1
Press the POWER switch on the front panel.
The POWER indicator should light, and the STATUS, BUSY and TAPE
indicators (with the SDX-D700C, the TAPE MOTION, CLEANING
REQUEST, and REPLACE TAPE indicators) should blink as the self-
test is performed.
2
When the three indicators stop blinking, you can insert a data cartridge as
shown below. The TAPE indicator will blink, and if the cartridge is
write-protected, the STATUS indicator will light. (With the SDX-
D700C, even if the cartridge is write-protected, only the TAPE MOTION
indicator lights.)
Figure 3-1. Inserting a data cartridge
3
Computer software controls the reading and writing of tapes. While
reading or writing, the BUSY indicator blinks. (With the SDX-D700C,
the TAPE MOTION indicator blinks.)