Connecting The Filter Pump To Your Pool - Aqua Leisure Simple-Set Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

G. Fill the pool with no more than 1 inch of water. Then smooth out any wrinkles or creases
in the floor by physically entering the pool and pushing out the area where the pool floor
meets the pool walls. A secondary method (from outside of the pool) is to reach under the
pool wall, grasp the pool floor, and pull outward.
H. Once you have removed all wrinkles in the floor, continue filling the pool. The pool
walls will rise as the water level rises. AS A SAFETY PRECAUTION, DO NOT
ALLOW BATHERS IN THE POOL UNTIL FILL-UP IS COMPLETE.
I. During fill-up, inspect the pool frequently to verify it is filling evenly. IMPORTANT:
If you notice water collecting unevenly or excessive sloping to one side, STOP
FILLING THE POOL IMMEDIATELY. This indicates that the ground is not level
enough, or that the wrinkles in the floor have not been properly smoothed out. If this
occurs, completely drain the pool (See section 6 in this manual) and then carefully
CARRY it to a more suitable site.
J. Continue to fill pool until the water level has reached the BOTTOM of the inflatable
ring, and the pool walls are smooth and firm. NEVER allow the water level to rise
higher than this point, as this may cause the pool to become unstable or collapse.
*IMPORTANT NOTE: Do not be alarmed if the outer walls of your pool appear to be wet,
as some "sweating" (appearance of condensation droplets on the pool) may initially occur after
set-up is complete, especially in cooler climates. This process is completely normal for this
type of pool and does not indicate any leakage. When sweating does occur it generally stops
within 72 hours of filling the pool.

3. CONNECTING THE FILTER PUMP TO YOUR POOL

At this time, please refer to the detailed instruction manual enclosed in the filter pump box. If
your pool system comes with pump model number SA-3768, please also refer to the strainer
& plunger valve installation instructions on the following two pages of this manual.
P.7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ss05-n

Tabla de contenido