Installing The Heating Cartridge - Truma AquaGo comfort Manual Del Usuario

4. Clamp the plug beneath the holder, as
shown in Figure 3.
Holder
Plug
Lug
Access
door
Fig. 3

Installing the heating cartridge

1. Turn OFF the water supply or switch OFF the
water pump.
2. Open a hot water faucet and leave it open in or-
der to depressurize and vent the water system.
6
3. Injuries caused by the
Easy Drain Lever! When the Easy Drain
Lever is folded out, it protrudes beyond the
side wall of the vehicle.
• When walking past or bending over,
make sure that you and others have suf-
ficient distance.
4. Open the latch with your thumb while pulling
the Easy Drain Lever down as far as it will go.
5. Remove the water inlet filter as shown in
Fig. 4a and rinse it with clean water.
Keep the water inlet filter in a safe place.
When you decalcify the Truma AquaGo™
instant water heater, you will need it for the
Truma AquaGo™ decalcification tablets.
6. Inspect the O-rings on the heating cartridge
for cracks. Replace the heating cartridge if
there are cracks.