Control Panel Features; Option Buttons; How To Use - Kenmore Elite Manual De Uso Y Cuidado

WARNING:
manual, including the Important Safety Instructions, before operating this dryer.

CONTROL PANEL FEATURES

H
A
POWER (ON/OFF) BUTTON
Press to turn the dryer ON. Press again to turn the
dryer OFF. Pressing the POWER button during a cycle
will cancel that cycle and any settings will be lost.
B CYCLE SELECTOR KNOB
The cycle selector knob is used to select the desired
dry cycle by rotating the knob in either direction until
the desired cycle LED is illuminated. Once the desired
cycle has been selected, the standard presets for that
cycle will show in the display. These settings can be
adjusted using the cycle modifier or option buttons
any time before starting the cycle (refer to pages 20
and 21).
C
START/PAUSE BUTTON
Press this button to start the selected cycle. The
dryer will display the estimated time (AUTO DRY) or
set time (TIMED DRY) remaining and start tumbling.
To pause the cycle at any time, open the dryer door
or press START/PAUSE. To resume the cycle where it
was stopped, press START/PAUSE again.
NOTE: If the dryer has been stopped for more than
four minutes, the dryer will turn off automatically.
D

OPTION BUTTONS

These buttons allow you to select cycle options.
Some of the option buttons have secondary
functions. The controls can be locked or unlocked by
pressing and holding the CONTROL LOCK button
for five seconds.
NOTE: To protect your fabrics, not all settings are allowed in all cycles.

HOW TO USE

To reduce the risk of fire, electric shock, or injury to persons, read this entire
G
A
G
B
E
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the settings for the
selected cycle. The settings light up above the
buttons to show the current selection (refer to page
24). The default temperature setting cannot be
changed in AUTO DRY cycles. AUTO DRY cycles are
modified using the DRY LEVEL button.
F
TIME AND STATUS DISPLAY
The display shows the estimated time remaining for
auto cycles and actual time for timed cycles. The
status of the cycle is also displayed. The CHECK
VENT indicator will illuminate if there is a serious
restriction in the exhaust system (refer to page 23).
G
STEAM FUNCTIONS
The STEAM REFRESH cycle uses a swirling jet of
steam to refresh clothes. The STATIC SHIELD and
EASY IRON options are also available for most
cycles (refer to page 26).
H
STEAM FEEDER
This drawer contains the reservoir for the water used
by the dryer to create the steam used for the steam
cycle and options. Fill the steam feeder with tap
water to take advantage of the power of steam for
fresher, static-free fabrics.
I
MY CYCLE
If you have a special combination of settings that
are used frequently, you can save these settings as a
MY CYCLE.
18
F D I
E C