Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear eye protection when operating or
performing maintenance on this tool.
Always turn off air supply and disconnect air supply
hose before installing, removing or adjusting any
accessory on this tool, or before performing any
maintenance on this tool.
LUBRICATION
Whenever a Series 88S Sander is disassembled for overhaul
or replacement of parts, lubricate as follows:
1.
Inject about 1.5 cc of Ingersoll–Rand No. 50 Oil into
the Inlet Bushing (4) after assembly.
2.
If the Sander is used in an extremely dirty
environment, once each week or after each forty
hours of operation, pour a liberal amount of a suitable
cleaning solution into the slots in the handle. Work the
throttle lever vigorously to wash the cleaning solution
around, then pour the solution and accumulated dirt
from the handle. Repeat this process until the cleaning
solution is clean when it comes out of the handle.
Immediately after flushing with the cleaning solution,
inject a liberal amount of Ingersoll–Rand No. 50 Oil in
the slots and, again, work the throttle lever vigorously
to lubricate the cleaned parts.
DISASSEMBLY
General Instructions
1.
Do not disassemble the tool any further than necessary
to replace or repair damaged parts.
2.
Whenever grasping a tool or part in a vise, always use
leather–covered or copper–covered vise jaws to protect
the surface of the part and help prevent distortion.
This is particularly true of threaded members and
housings.
MAINTENANCE SECTION
3.
4.
Disassembly of the Motor and Throttle
1. Grasp the flats of the live air handle in leather–covered
2. Remove the Cylinder Case Screws (45), the Lock
3. Remove the Sander from the vise.
4. Grasp the Arbor (27) in leather–covered or copper–
5. Remove the Controller Retaining Ring (40) and
6. Lift off the Rotor Bearing Seal (37) and the Rear End
7. Lift off the Cylinder (33).
8. Remove the Vanes (32).
9. Withdraw the Rotor (31) and lift out the Rotor
10. Remove the arbor and end plate assembly from the
16
Do not remove any part which is a press fit in or on a
subassembly unless the removal of that part is
necessary for repairs or replacement.
Do not disassemble the Sander unless you have a
complete set of new gaskets and O–rings for
replacement.
or copper–covered vise jaws with the Spindle upward.
Washers (44), the Motor Retaining Plate (43), Cylinder
Case Gasket (42) and the two Motor Clamp Washers
(41).
covered vise jaws. Lift off the Cylinder Case to expose
the motor.
Use only the special No. 88V60–950 Controller
Wrench for removing the Controller Assembly (39).
Do not attempt to disassemble the Controller. It is
available only as a unit and is guaranteed for the
life of the tool if it is not abused.
unscrew the Controller Assembly which has a
left–hand thread that requires a clockwise rotation
for removal.
Plate (35).
Key (30).
vise. Grasp the Front End Plate (29) in one hand and
tap the small diameter end of the Arbor (27) with a
soft hammer to remove the End Plate.
Publicidad
