Aqua Medic aquarius plant 60 Manual De Instrucciones página 8

Do not try to repair the lighting system. Please send it in for checking, preferably with a list of
•
defects and a copy of invoice, if applicable. Also, broken LEDs can be exchanged only by the
manufacturer.
When working on the light, always pull all power plugs.
•
4. Installation
The light is either mounted with the
included fittings at the aquarium. The aquarius
avoided that any water, either by spraying or by condensation, enters the light. Therefore, do not
mount it too close to the water surface. The
aquarium so that it does not overheat.
4.1. Mounting of ceiling suspension (not included in shipment):
The optional wire suspension aquafit 2 provides a neat and simple method of ceiling mounting of
the aquarius plant.
To secure the aquafit 2 at the
They replace the screws holding the assembled side caps.
The suspension system consists of the following (2 pcs. each):
1. Ceiling suspension incl. screws and plugs, 2 metres of stainless steel incl. stopper
2. Lamp fixing (cable with Y-piece, with end sleeves)
First of all, both the ceiling suspensions (1.1) have to be mounted to the ceiling securely by using
screws and plugs. The screws for mounting the Y-wire to the light are supplied with the aquarius
plant. They replace the screws holding the assembled side caps.
Stainless steel cable:
Now, the stainless steel cable is fed through the nut (1.3) of the ceiling suspension so that the
stopper (1.2) is placed inside the ceiling suspension. The nut is screwed onto the ceiling suspension
allowing the stainless steel cable to hang free.
Fixing of the lamp:
The stainless steel cable is fed through the lamp fitting of the Y-piece from the top (2.1.1). It
comes out of the lateral opening (2.1.2) and then it has to be pulled out and adjusted to the
correct height above the aquarium. When the lamp is levelled, the locking bolt (2.2) is tightened in
order to prevent an unintentional tilting of the lamp.
Release the fixing:
The lamp includes a non-return mechanism so that the cable can easily be adjusted. If more cable
is needed or the lamp shall be taken down, press the fixing screw (2.1.1) with your finger. - Note:
Hold the lamp tightly. The stainless steel cable can now be removed from the lamp fixing.
When the lamp is mounted in the correct position, any surplus wire may be cut off with pliers.
8
optional
wire suspension aquafit 2 on the ceiling or with the
plant
aquarius
aquarius plant, four matching screws are supplied with the light.
is not waterproof. It has to be absolutely
plant has to be mounted openly above the