Safety And General Information; Product Description; Rated Capacity - Pro-Lift Garage in a Box Manual De Piezas E Instrucciones De Funcionamiento

SAFETY and GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.

PRODUCT DESCRIPTION

Pro-Lift Garage in a Box comes with a 2 Ton Floor Jack, 2 Ton Jack Stand pair, 2 Wheel Chocks and a detachable
creeper. Floor Jacks are designed to lift, but not support one end of a vehicle. This Floor Jack must be used in
conjunction with the pair of Jack Stands provided. The Jack Stands are used in pairs to support one end of the vehicle.
The Wheel Chock are design to prevent inadvertent rolling of the vehicle while lifting and support, however they
should not be used as a support device. The Creeper is intended to support and move along a smooth level surface.
SPECIFICATIONS
Description
Floor Jack
Jack Stand
Creeper
Wheel Chock
Carrying
Handle
Lifting Arm
Saddle
Front Wheel
Engage release
valve w/this end
Figure 1 - Typical Floor Jack Nomenclature
Locking Handle
Press Tab
Figure 2 - Typical Jack Stand Nomenclature

Rated Capacity

2 Ton
2 Ton (per Pair)
300 lbs.
2000 lbs.
Cover Plate
Oil Filler Plug
(remove to access
(not shown, on
oil filler plug)
reservoir)
Handle
Saddle
Ratchet Bar
Ratchet Pawl
Base Frame
Base Dimensions
(L x W)
17-1/2" x 8"
7-3/8" x 6-5/8"
36" x 15"
5-1/8" x 3-5/8"
Handle Sleeve
Release Valve
Rear Caster
Handle Grip
Figure 3 - Detachable Creeper Nomenclature
2
Min. Height Max. Height
5-3/8" 13-1/8"
10-1/8" 16-3/8"
4" N/A
N/A N/A
Casters
Figure 4 - Wheel Chock Nomenclature
Connector
Support Bar