Cleaning The Player; Connecting The Unit - JB Systems USB3.1-RDS Manual De Instrucciones

ENGLISH
INSTALLATION GUIDELINES:
 Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights,
etc. will affect its performance and may even damage the unit.
 Take care to minimize shocks and vibrations during transport.
 When installed in a booth or flight case, please make sure to have good ventilation to improve heat
evacuation of the unit.
 To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when
bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full
performance.
 Choose the place where you put your installation very carefully. Avoid presence of heat sources. Avoid
places with vibrations or places that are dusty and humid.
 The player will work normally when installed on a surface with max. 15° inclination.
 Be very careful while handling CDs, do not touch them with wet or dirty hands.
 Discs that are dirty must be cleaned with special designed cloth and cleaning products.
 Do not use CDs that are badly damaged (scratched or deformed) they can damage your appliance.
 To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
 In order to prevent electric shock, do not open the top cover. If a problem occurs, contact your dealer.
 Do not place metal objects or spill liquid inside the player. Electric shock or malfunction may result.
 This player uses the semiconductor laser. To allow you to enjoy music at a stable operation, it is
recommended to use this in a room of 5°C – 35°C.
 The compact disc player should not be adjusted or repaired by anyone except properly qualified service
personnel.
 This unit may cause interference to radio and television reception.

CLEANING THE PLAYER:

Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water inside the unit. Do not
use volatile liquids such as benzene or thinner which will damage the unit.

CONNECTING THE UNIT

1. MAINS input with IEC socket and integrated fuse holder: connect the supplied mains cable here. Never
repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type
and with the same electrical specifications (T500mA /250V)
2. DC 24V input connector : can be used to connect you back-up power supply (if needed)
3. RS-232 connector: can be used to control the unit via external hardware so the unit can be integrated in
automated systems, etc. You can find the list with commands on the last page of this manual.
4. Variable Audio Output: This combined output sends out the audio signal of the CD player, the USB or
SD media player and the Tuner
5. Fixed Audio Output CD/MEDIA: This output will only send the audio signal of the CD player and the
USB or SD media player. It doesn't include the audio signal of the Tuner. This means you can use 2
sources at the same time (for multi-zone applications) and send the signal of the CD or USB / SD media
player to one room or zone, while the audio signal of the tuner can be sent to another room or zone.
6. Fixed Audio Output Tuner: This output will only send the audio signal of the Tuner. It doesn't include
the audio signal of the CD player and the USB or SD media player. This means you can use 2 sources
at the same time (for multi-zone applications) and send the signal of the CD or USB / SD media player to
one room or zone, while the audio signal of the tuner can be sent to another room or zone.
7. 75 Ohm Antenna connection: can be used to connect the supplied FM antenna (or another FM
antenna)
8. 300 Ohm Antenna connection: can be used to connect an AM antenna
JB SYSTEMS
®
3/35
OPERATION MANUAL
USB3.1-RDS