Cleaning And Maintenance; Protecting The Environment - BLACK&DECKER PAV1205 Manual De Instrucciones

ENGLISH
The extension can be retracted by pressing the button
(14) and pushing the extension (7) back into the dust
collector.
The dust collector (8) should be returned to the storage
position under the appliance after use.
Fitting the accessories (fig. C & D)
The appliance is supplied with the following accessories:
Two brush tools (10 & 11) for upholstery
An extension hose (12)
A hose connector (13)
Note: The brush tool (10) can be fitted into the front of the
appliance, the right-angled brush tool (11) can be fitted to the
end of the extension hose (12).
To fit an accessory, proceed as follows:
Insert the brush (10) into the front of the appliance.
Alternatively, fit the hose connector (13) onto the nose
of the appliance and attach one end of the hose (12) to
the connector.
Attach the right-angled brush tool (11) to the other end
of the hose.
When not in use, the accessories can be stored in the
storage bag (9).
Use
Connecting to the vehicle's power supply (fig. E)
Make sure that the appliance is switched off.
Remove the cigarette lighter from it's socket.
Plug the connector (6) into the cigarette lighter socket.
Switching on and off (fig. F)
To switch on, slide the on/off switch (4) forward.
To switch off, slide the on/off switch back.
The appliance can be used for periods of up to 30 minutes
without noticeably affecting the power of a normally charged
car battery in good condition.
Warning! Extended use will drain the battery power. Do not
run the vehicle's engine while cleaning as this can shorten
the life of the appliance.
Optimising the suction force (fig. G)
In order to keep the suction force optimised, the filters must
be cleared regularly during use.
Rotate the filter cleaning wheel (5) a few turns to shake
out dust clogging the filters (15 & 16).

Cleaning and maintenance

Warning! Regularly clean the filters (15 & 16).
Cleaning the dust bowl and filters (fig. H - I)
The filters are re-usable and should be cleaned regularly.
6
Press the release latch (1) and open the container door
(2) (fig. H).
Empty the dust container.
Remove the filters (15 & 16) by twisting them counter-
clockwise (fig. I).
Brush any loose dust off the filters.
Wash the filters in warm, soapy water (fig. J).
Make sure that the filters are dry.
Refit the filters (15 & 16) on to the appliance, twisting
them clockwise until they lock into place.
Close the container door (2). Make sure that the release
latch (1) clicks into place.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your Black & Decker dealer (cat. no. VF50):
Remove the old filters as described above.
Fit the new filters as described above.

Protecting the environment

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your appliance
needs replacement, or if it is of no further use to
you, think of the protection of the environment.
Black & Decker repair agents will accept old
Black & Decker tools and ensure that they are
disposed of in an environmentally safe way.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have
reached the end of their working life. To take advantage of
this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of