JBS mix6 Manual De Instrucciones página 6

ENGLISH
11. POWER LED: Is lit when the power is switched on
12. POWER SWITCH: Used to switch the mixer on and off.
13. MASTER OUTPUT KNOB: Adjusts the output level of the master output.
14. CUE LEVEL: Used to adjust the output level of the headphones. Note that, due to the high output power,
you can permanently damage your ears! Do not play at high volume!
15. CUE MIXING KNOB: With this control you can mix the master output with the cue signals from the
different channels and the effect unit. Turn this control complete to the right if only want to hear the
master output. Turn it completely to the left and you will only hear the cue signals that are selected with
the cue buttons (20). At any position in between you will hear a mix of both signals.
16. SPLIT CUE BUTTON: Normally you hear a stereo signal in your headphones. When you press this
button, you will hear 2 different mono signals:
a. LEFT: Cue signals, selected with the cue buttons (20).
b. RIGHT: Signal on the master output.
Note that the Cue mixing knob must be in the center position!
17. HEADPHONES OUTPUT: Used to connect any headphones with 6,3mm jack plug.
18. TALKOVER LEVEL: You can adjust the amount of muting on input channels 1 to 4. The more you turn
the talkover level to the right, the more these channels are muted while talking through the Microphones.
19. BOOTH OUTPUT KNOB: Adjusts the output level of the booth output.
20. CUE SELECTOR: Used to select the source (CH-1 to CH-4) to be monitored via the headphones output.
Pressing multiple Cue-buttons makes it possible to derive a mixed sound from the selected sources.
21. CROSSFADER ASSIGN: With this switch you can select if the channel needs to be use with the
crossfader (select X or Y) or if the signal can be routed directly to the master output (select MASTER) .
22. CROSSFADER: With this fader you can mix over between the channels you selected with the
crossfader assign selectors (21). The crossfader only works when you move the selected channel faders
(8) to the desired level!
23. CROSS FADER CURVE: Adjusts the curve of the cross fader from smooth (left position) to sharp (right
position).
FUNCTIONS (REAR)
24. MAINS INPUT: with IEC socket and integrated fuse holder, connect the supplied mains cable here.
25. MASTER BALANCED OUTPUT: The XLR-connectors can be used to connect the mixer to any
balanced amplifier input, using special balanced signal cables.
26. MASTER UNBALANCED OUTPUT: The same output signal as on the balanced master output(25) but
unbalanced. Can be used to connect unbalanced amplifiers.
27. RECORD OUTPUT: Carries the same signal as the master outputs but is not influenced by the master
level. Used to connect analog recording equipment. You can also connect a computer for direct digital
recording, see USB connection (32).
28. INPUT CHANNEL 3 (PHONO/LINE): used to connect two different audio signals: phono or line. Use the
push button below to change the input between line and phono. The input source selector (7) on the
front determines which input will be active: phono/line (28) or line (35).
29. INPUT CHANNEL 2 (PHONO/LINE): used to connect two different audio signals: phono or line. Use the
push button below to change the input between line and phono. The input source selector on the front
determines which input will be active: phono/line (29) or line (34).
30. INPUT CHANNEL 1 (LINE): used to connect LINE audio signals. The input source selector on the front
determines which input will be active: USB (32) or line (30).
JB SYSTEMS
®
4/33
OPERATION MANUAL
MIX6 USB