Use - Hardware; Use - Hardware Release Lever - Permobil BodiLink Serie Manual De Instrucciones

USE - HARDWARE

Removing and reinstalling Power Mount Hardware.
WARNING: Hardware should be removed before transferring into the wheelchair.
1 To remove the hardware from the mounting block, pull the release lever (A) up (or down)
until the lever remains in the open position (~90°). Pull the hardware post (B) straight up
and out of mounting block (C).
2
To re-install the hardware, insert the post (B) straight down into the mounting block
receiver (C) until the post is fully seated.
Note: The release lever can be open or closed when inserting the post.
3
Once the hardware is fully inserted into the mounting block, ensure that the release
lever is fully closed and the hardware is engaged before use.
Note: Release levers on the hardware have a hole near the end for an optional trigger pull
lanyard. (Lanyard is not provided and should only be used at a therapist's discretion.)
A

USE - HARDWARE RELEASE LEVER

Switching the removable hardware release lever orientation. The lever location and orientation are subject to user/caregiver
preference and ability to operate.
1 Firmly grasp the sides of the release lever base and pull straight out.
2
While the lever is pulled out from the mounting block/base, rotate the lever 180° and release in the new position.
Note: To switch the location of the lever from the front to the rear of the mounting base/block, switch the left and right-hand side hardware (or
rotate 180° for power mount) during installation. Refer to the Hardware installation instructions in this manual.
Power Mount
Hardware shown
BodiLink on Permobil Corpus Operation Manual
14
C
LPTS
B