Maintenance And Warranty - Permobil BodiLink Serie Manual De Instrucciones

MAINTENANCE
INSPECTION
Inspect all components of the equipment weekly.
Check and tighten all fasteners and adjustment points.
Inspect all materials for wear such as stretching, fraying,
fractures, and bends. Some wear with regular use is expected.
Components that show excessive wear should be replaced. For
information on replacements, refer to the "Warranty" section in
this manual.
WARNING: DO NOT continue to use the product if any
part is broken or cannot be tightened. Periodically, the product
should be thoroughly inspected by an equipment provider.
REUSE
You must re-fit the support to the new user or after extended
periods of non-use by the same user. Refer to the adjustment
and use instructions in this manual.
Before transferring to a new user, the product must be
completely cleaned and disinfected. Refer to the cleaning and
disinfecting instructions in this manual.
STORAGE
Assembly or individual parts should not be stored in extreme
hot or cold temperatures. Only store in a clean and dry place at
room temperature.
Do not allow exposure to direct sunlight for prolonged periods
of time. This could age the product more rapidly and decrease
its effectiveness.
Do not store where there is risk of open flame or spark.
DISPOSAL
Dispose of the product and/or components in accordance with
the applicable regulations in your jurisdiction.
CAUTION! DO NOT INCINERATE as a means of disposal.
BodiLink on Permobil Corpus Operation Manual
WARRANTY
This product is covered by a lifetime warranty against
manufacturer defects. If a manufacturing defect should occur,
discontinue use immediately; note that the product will be
replaced at no cost to the buyer. Wear from regular use is not
considered a manufacturing defect. Replacement parts are
available by contacting your supplier, distributor, or retailer.
The following will void the warranty: modifications made in
attempt to interface with other products (where compatibility is
limited, as described in product information); alterations made
to the product; or defects caused by irregular use.
WARRANTY REPLACEMENT PROCEDURE
Warranty claims should be initiated by the original purchaser,
who should contact the DME supplier, distributor or retailer
from whom the product was purchased, if they are available, or
any authorized Permobil DME supplier, distributor or retailer.
Whenever possible, the DME supplier, distributor or retailer
with a warranty issue should contact Customer Support and
provide the original purchase order number, sales order
number, or invoice number. Before a warranty replacement
order or quote may be processed, Customer Support must
issue a Return Merchandise Authorization (RMA).
16