Fusion MS-RA70NSX Instrucciones De Instalación página 4

Wire Function Wire Color/ Notes
Number
Zone 2 line out (left) Provides a full-range output to an external
amplifier, and is associated with the volume
Zone 2 line out
control for zone 2.
(right)
Subwoofer out Each cable provides a single mono output to a
powered subwoofer or subwoofer amplifier,
and one or both cables can be used,
depending on the connection requirements of
the subwoofer or amplifier.
A connected subwoofer is associated with the
volume control for zone 1.
Connecting to Power
When connecting the stereo to power, you should connect it through the
ignition or another manual switch.
If it is necessary to extend the power and ground wires, use 14 AWG
2
(2.08 mm ) wire. For extensions longer than 1 m (3 ft.), use 12 AWG
2
(3.31 mm ) wire.
1
Route the power wire to the ignition or another manual switch
route the black ground wire to the battery.
2
If necessary, route a wire between the switch and the battery .
3
Route the wiring-harness plug to the stereo.
Do not connect the wiring harness to the stereo until after all of the bare
wire connections have been made.
4
Connect the black wire to the negative (-) battery terminal.
5
Connect the power wire to the ignition or another manual switch, and
connect the switch to the positive (+) battery terminal if necessary.
6
Connect the wiring harness plug to the stereo.
Speaker Zones
You can group speakers in one area into speaker zones. This enables you to
control the audio level of the zones individually. For example, you could make
the audio quieter in the cabin and louder on deck.
You can set the balance, volume limit, subwoofer level, and name for each
zone.
Single-Zone System Wiring Diagram
Speakers
Water-tight connection
4
Complete System Wiring
, and
Item Description
Zone 2 speakers
Water-tight connection
Powered amplifier
Zone 2 line out
Amplifier-on signal wire
Zone 1 speakers
Zone 1 line out
Zone 1 subwoofer out
Each cable provides a single mono output to a powered subwoofer or subwoofer
amplifier, and one or both cables can be used, depending on the connection
requirements of the subwoofer or amplifier.
Powered subwoofer
NMEA 2000 System Wiring Diagram
NOTE: NMEA 2000 is available on FUSION MS-RA70NSX models only.
Stereo
Supported chartplotter MFD or compatible FUSION NMEA 2000 remote control
In-line switch
NMEA 2000 power cable
NMEA 2000 drop cable from the stereo, up to 6 m (20 ft.)
NMEA 2000 drop cable from the chartplotter MFD or compatible FUSION NMEA
2000 remote control
9 to 16 Vdc power supply
Installation Instructions