Kathrein UFOcompact plus UFO 834 Manual De Instrucciones página 8

Installation
Slide the UFO 834 into any available slot. If baseband data to be exchanged
(e.g. UFZ 896) with a different module, the UFO 834 which must be arranged right or left.
Make sure that the UFO 834 is fully inserted and that the contact is made to the backplane
(the front plate of the UFO 834 is located on the front of the base unit).
Fix the two thumbscrews up and down (Torx screws). The UFO 834 is automatically re-
cognised by the UFX 800. When the UFO 834 reaches the proper operating condition, the
green LED lights up. All other operating instructions, refer to the manual in the USW 800
operating software.
Operation
The operation of the UFO 834 via the graphical user interface of the control software USW
800; online help describes the confi guration of all modules, including the UFOcompact
plus UFO 834. All other setting instructions, refer to the manual/online help of the USW
®
800.
Note: The up to date version of the USW 800 and its instructions are available free to
download on the Kathrein website "www.kathrein.de".
Waste/Recycling note
Electronic equipment is not domestic waste - it must be disposed of properly in
accordance with directive 2002/96/EC OF THE EUROPEAN PARLIAMENT AND THE
COUNCIL dated 27th January 2003 concerning used electrical and electronic appli-
ances. At the end of its service life, take this device for disposal at a designated public
collection point.
Internet: www.kathrein.de
KATHREIN-Werke KG • Anton-Kathrein-Straße 1-3 • P.O. Box 10 04 44 • 83004 ROSENHEIM • GERMANY • Phone +49 8031 184-0 • Fax +49 8031 184-306
936.4606/-/VKDF/0813/GB - Technical details subject to change.