POS.
DENOMINAZIONE
1A
ELECTRIC MOTOR 800W 12V
1B
ELECTRIC MOTOR 800W 24V
1C
ELECTRIC MOTOR 500W 12V
2
SUN GEAR
3
PLUG
4
FIXED GEAR
5
SCREW
6
RING Ø 80
7
FIFTH WHEEL
8
PLANT GEAR
9
MOVABLE GEAR
10
BEARING
11
CIRCLIP
12
KEY
13
SCREW
14
PRESSURE LEVER
15
SPRING FOR PRESSURE LEVER
16
SCREW FOR PRESSURE LEVER
17
PLUG
18
WASHER
19
IDLER GEAR
20
BEARING
21
PLUG
22
SCREW
23
WINDLASS BASE
24
BEARING
25
CIRCLIP
26
OUTPUT GEAR
27
PLUG
28
SHORT SHAFT
29
OIL SEAL
30
WINDLASS COVER
31
ASSEMBLED SENSOR
32
ROPE/CHAIN STRIPPER
33
SCREW
34
WINDLASS CLUTCH
35A
GYPSY "GP2"
35B
GYPSY "GP2" 7 MM - 1/4"
35C
GYPSY "GP2" 8 MM
35D
GYPSY "GP2" 5/16"
36
GYPSY COVER
37
WINDLASS LEVER - NYLON
38
GASKET/JIG
39
STUD
40
WASHER
41
SPRING WASHER
42
NUT
43
CABLE
44
SCREW
45
GASKET WATERTIGHT
46
GASKET WATERTIGHT
47
KEY
48
DRUM
49
BUSH
50
PLUG
51
GROWER
52
PLUG
53
CABLE OUTLET
GP2 SERIES GENIUS 1500/2000 - REV001B
WARNING: make sure the electrical power to the motor is
switched off when working manually on the windlass. Careful-
ly remove the chain from the gypsy.
Quick
windlasses are manufactured with materials resistant to ma-
®
rine environments. In any case, any salt deposits on the outside must
be removed periodically to avoid corrosion and damage to the equip-
ment. The parts where salt may have built up should be washed
thoroughly with fresh water.
Once a year, the drum and the gypsy are to be taken apart as follows:
VERSION WITH FREEFALL SYSTEM
Use the handle (37) to unscrew the gypsy cover (
H
(
) and take off the gypsy cover. Loosen the screws (33) of the chain
stripper (32) and remove it; remove the gypsy (35).
NO-DRUM VERSION
Use the handle (37) to remove the gypsy cover (36); remove the top
clutch cone (34); loosen the fixing screws (33) of the chain stripper
(32) and remove it and pull off the gypsy (35).
DRUM VERSION
Use the handle (37) to loosen the bush (49); pull off the drum (48) and
the top clutch cone (34); loosen the fixing screws (33) of the rope/
chain stripper (32) and remove it. Pull off the gypsy (35).
Clean all the parts removed to avoid corrosion, and grease the shaft
A
thread (28, 46 or
) and the gypsy (35) where the clutch cones rest
(use grease suitable for marine environment) (34).
Remove any oxide deposits from the terminals of the electric motor
and the reversing contactor unit; grease them.
MAINTENANCE
F
); loosen screw
EN
19