Troubleshooting - Truper CAZ-EL-4-1/2N2 Manual De Instrucciones

Start up
Operation
• Use a marker or a grease pencil and mark the cutting line onto
the material. The work piece should be properly fastened.
• If you need damp cuts, open the water supply to start the water
flow.
• Support the front side of the shoe on the workpiece, which
must be properly fastened with clamps or brackets, align the
cutting wheel with the line drawn.
• Start the cutter and wait for the wheel to reach its highest speed
and is totally wet.
• Push the cutter forward slowly and firmly in order to cut the
piece.
• Keep a constant speed pushing and avoid any unstable
movements.
• Keep a constant speed pushing and avoid any unstable
movements.
• Stop the water flow.

Troubleshooting

Problem Cause
The tool is not • Short circuit inside the motor.
working after plugging
it to the power
source.
After connecting the • There is a mechanical obstruction.
tool to the power • Short circuit inside the motor.
source it makes an
unusual noise and the
wheel rotates slowly.
The cogwheel box • Not enough lubricant, or the lubricant is dirty.
gets very hot.
• The cogwheel is too tight or there are residues
inside.
The motor rotates but • The cogwheel teeth are broken.
not the wheel.
The motor surface • Excessive load on the motor.
gets too hot. • Dampness.
• Incorrect Assembly.
• Voltage Drop.
Strong flaming in the • Short circuit in the motor.
collector or • The surface on the commuter is dirty.
commuter. • Worn Carbon.
Cross-section Cut Diagonal Cut
Miter Cut
Solution
• Go to a
Center.
• Go to a
Center.
• Add lubricant or have it replaced at a
Authorized Service Center.
• Go to a
Center.
• Go to a
Center.
• Reduce the load over the motor.
• Dry the motor.
• Check the motor at a
thorized Service Center.
• Adjust the to the proper voltage.
• Go to a
Center.
• Change the carbons.
"L" Cut
Authorized Service
Authorized Service
Authorized Service
Authorized Service
Au-
Authorized Service
9
ENGLISH