Publicidad
Idiomas disponibles
Idiomas disponibles
1.1. ACCESSORIES.
A series of accessories are required to correctly install the equipment and use it appropriately. These must
be chosen in agreement with the table below.
Earth cable.
Wire drives rollers.
Protection hand screen.
Recommended torch.
Recommended pressure
reducing valve.
Gas economiser system.
FOR THE USE OF ANY OTHER ACCESSORY CONSULT THE MANUFACTURER.
GALA MIG 255 M. Technical Instructions Manual
Accessories included in the GALA MIG 255 M
MINIMUM PROTECTION TONE 11. (HAND SCREEN Ref. 675.00.03)
Recommended accessories.
3XM-25 (Hilo 0,8-1.0 mm) ; 3XM-36 (Hilo 1,0-1,2 mm)
315 Kg./cm
ARGON-MIX (ECNONOGALA MOD. Ref. 355.00.000)
Reference
Model
880015X
3 XM-25
880025X
3 XM-25
880036X
3 XM-36
EN-2 Ar-CO2 Ref: 376.00.000
INTAKE PRESSURE (bar)
OUTLET PRESSURE (bar)
NORMAL FLOW Q
MAXIMUM FLOW Q
ECONOGALA REF: 355.00.000
The Econogala economiser valve is capable of saving up to 50% of the
consumption of any welding shielding gas, use in MIG-MAG-TIG procedures.
In case of spot welding it is possible to be obtained up to a 50% of saving, in
the welds of long joints the saving can be around 20%.
It is easy and simple to install, not needing any type of special coupling. It
must be next to a pressure reducing valve with single expansion chamber.
L= 4 m; S= 35 mm
Ref. 438.12.219
0.8-1.0 mm ∅30-"V"
Ref. 49216022
2
28 L/min. (MOD. EN-2 Ar-CO
3 XM Torch
Welding intensity
100 %
60 %
115
150
155
200
235
300
1
maz
2
- Ref. 376.00.000)
2
Wire Ø
(Recommended)
35%
195
0.6 - 0,8 mm
260
0,8 - 1 mm
395
1 - 1,2 mm.
200
10
20 Nl/ min
28 Nl/ min
15
Publicidad
