Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
PREPARING
THE
UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days,follow this procedure:
I.
Flush detergent siphoning tube by placing filter into a
pall of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2.
Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spark plug.
3.
Empty pump of liquids by pulling engine recoil handle
about 6 times. This should remove most liquid in
pump.
4.
Use pump saver to prevent corrosion build up and
freezing of pump.
5.
Store unit in a clean, dry area.
Protecting
the Pump
To protect the pump from damagecaused by mineral
deposits or freezing, use PumpSaver to treat pump. This
prevents freeze damageand lubricates pistons and seals.
NOTE: PumpSaver is availableas an optional accessory. It
is not included with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
CAUTION
• Failure to do so will permanently
damage your pump and
render your unit inoperable.
• Freezedamageis not coveredunder warranty.
CAUTION
Alwayswear eyeprotection when usingPumpSaver.
To use PumpSaver,make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
NOTE:
PumpSaver will drip from pump after treatment
and will stain wood and concrete.
NOTE:
If PumpSaver is not available, draw RV antifreeze
(non-alcohol)
into the pump by pouring the solution
into a
3-foot section of garden hose connected
to inlet adapter
and pulling recoil handle twice.
STORING
THE
ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
m
Publicidad
