Troubleshooting - CORBERO CCMD60320PD Manual De Instrucciones

TROUBLE SHOOTING
Fault
The blades are blocked.
The capacitor is damaged.
Light on, but
The motor is damaged.
motor does not
The internal wiring of motor is cut off/
work
disconnected. An unpleasant smell
may be produced.
Apart from the above mentioned, check the following:
Both light and
Light damaged.
motor do not
Power cord loose.
work
Outlet and the air ventilation entrance
Oil leakage
are not tightly sealed.
The blade, if damaged, can cause
vibrating.
Vibration
The motor is not tightly fastened.
The cooker hood is not tightly fixed.
The distance between the cooker
hood and the cooker top is too large.
Insufficient
suction
Too much ventilation from open doors
or windows.
The fixing screws are not tight
The
enough.
machine
The hanging screws are not tight
inclines
enough
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain,
and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the
appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of their old
appliance.
Cause
EN-10
Solution
Check the blades.
Replace capacitor.
Replace motor.
Replace motor.
Replace lights.
Connect the wires as the electric
diagram.
Take down the outlet and seal with glue.
Replace the blade.
Fasten the motor tightly.
Fixed the cooker hood tightly.
Readjust the distance.
Choose a new place to install the
appliance or close some doors / windows.
Tighten the fixing screw and make it
horizontal.
Tighten the hanging screw and make it
horizontal.