Steren PAR-030 Manual De Instrucciones página 24

Use of the equipment with DMX controller
To make the connections take into account that this device is equipped with 3
pole XLR connectors with the following pin settings: 1 = earth, 2 = DMX - 3 =
DMX +.
You can control devices individually using a driver; use a canon cable to connect
the PAR-030 INPUT to the output connector of the DMX light controller.
You must select the d001 or A001 operation modes on the main lamp using the
Menu button, then select a starting direction on the DMX channel using the UP
(increase) and DOWN (decrease) buttons.
Remember to set an available mode for each lamp when you use chain
connection.
Never use a "Y" connector to make a split connection.
Do not connect the device to the mains through a dimmer.
10 10
0.1 SEC 30S
10.MIN 0
D
D M
CANNON CABLE CANNON CABLE CANNON CABLE