Ools; P Reventive Maintenance; R Epair; Arranty - SUHNER MACHINING MH 20/5 Documentación Técnica

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
3.2 t

OOls

The multiple spindle heads are not suitable for
carbide tools.
Handle tools and attachments with care, keep
them clean and sharp, and observe the manufacturer's
instructions on the use of coolants and tool receivers.
Use the attachments intended for each application. Do
not trim attachments for applications they have not been
designed for.
Always use speeds and feed rates assigned to the attach-
ment and material, and do not exceed the machine's and
the tool's max speed.
Never remove chips with your bare hand, but always use
e.g. hooks, etc.
The stated maximum speed must not be exceeded.
For continuous operating temperatures of 60-80 ° C are
considered to be normal.
4. s
ErvicE
4.1 p
reVentiVe mAintenAnce
The gearing and bearings are fitted with oil batch lubri-
cation. Change the oil after about 500 operating hours.
The oil is replenished and drained through the inspection
glass. Use only oil that is free of resin and acid (Shell Tel-
lus S2 M68 or similar).
4.2 r
epAir
If despite strict observance of the manufacturing and test-
ing method the multiple spindle head should happen to
fail, it must be repaired by an authorized SUHNER agency.
4.3 w

ArrAnty

In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the multiple spindle head is returned in the
undisassembled condition.
4.4 s
tOrAge
Temperature range: 20°C to +50°C.
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d
/ e
ispOsAl
nVirOnmentAl cOmpAtiBility
The multiple spindle head consists of materials that can
be introduced to recycling. Before disposal, render the
multiple spindle head inoperable.
20
/m
aintEnancE
Do not introduce the multiple spindle head to the
domestic waste cycle. The national regulations
stipulate that this multiple spindle head is intro-
duced to environmentally compatible recycling.

Publicidad

Tabla de contenido
loading

Tabla de contenido