Assembly And Use - Sienna Luna SSM-3006 Manual De Instrucciones

ASSEMBLY AND USE

1) Attach handle to steamer body by pressing handle release button located on the top front of
steamer body and insert handle into steamer body.
2) Attach steamer body to steamer head by pressing steamer head release button located on the
bottom back of steamer body and insert steamer body into steamer head.
3) Set cloth pad on the floor with microfiber side down. Align self adhesive strips at the bottom
of steamer head with cloth pad. Place steamer head on top of cloth pad and apply pressure to
assure hold.
4) Unscrew the water tank cap and fill with cool tap water by using refill cup provided.
NOTE: To ensure only the highest quality products are produced, Sienna has pre-tested all steam
mops. This is why you may see some water Condensation on the inside of the water tank. The
steam mop does not require distilled water. Residents in areas with hard water should use
distilled water for better performance.
5) Twist the quick release cord wrap clockwise to unwrap the power cord completely.
NOTE: It is recommended that another high wattage appliance is not operated on the same
circuit to avoid a circuit overload.
NOTE: There is a metallic ball located in the water tank that can get lodged inside. Shake the
body of your unit, if you hear the ball rattle, then you are ready to start steaming. If not, shake
your unit to release the ball.
5