Solo 582 Manual De Funcionamiento página 22

Problem
Rough running,
vibrations
Engine will not start
Engine runs irregular
Starter rope kicks back - engine mounting screws loose
Lawn turns yellow
Low quality cut
Mower does not
collect properly
In accordance with Product Liability Laws, our company cannot be held responsible for any damage caused
by improper handling or repair or use of non-original SOLO parts or parts approved by us or if repairs
were not made by an authorized service center. This also refers to accessories and supplementary parts.
22
Possible Cause
-Loose engine screws
-Loose blade screw
-damaged or unbalanced blade
-friction clutch worn
-Engine brake lever pressed
correctly?
-Engine Reg. Lever in correct
position ?
- cable for engine brake correctly
adjusted ?
- plug or plug cap defect?
- fuel tank empty
- air filter dirty
- bent / damaged throttle cable
- spark plug dirty
or friction clutch loose
- blade is blunt
- cutting height too low
- engine rpm too low (582)
- too low engine rpm (582)
- cutting height set too low
with high grass
- speed too high when pushing
- blade worn
- catcher fabric clogged
Solution
-tighten screws
-check blade tightening
-balance or replace blade
-replace friction washers
- press/pull brake lever
correctly.
-select correct position
- check adjustment
- clean or replace plug or cap
- refuel
-clean air filter or replace
- adjust / replace cable
- clean plug
-tighten blade
- sharpen blade
- adjust cutting height
- set Eng. Reg. Lever to max. (582)
- set Eng. Reg. Lever to max. (582)
-adjust cutting height
- Push lawnmower more slowly
-replace blade
-clean catcher or replace