THERMOBILE
Cleaning and maintenance
Cleaning the air filters
Trouble shooting
TROUBLE
DOES NOT
WORK
POOR
COOLING
Accessories
DUCT
COLD
AIR
DUCT COVER (FINISHING COLLAR)
OUTLET
CONNECTION FLANGE
ALUMINIUM FILTER CASSETTE
REDUCER
HOT AIR
EXHAUST
ALUMINIUM FILTER CASSETTE
Coolmobile 21-25
1. To remove filters,
slide up a little 1 and
pull towards you 2.
2. Clean the filters with
water or compressed
air.
3. Clean evaporator and
condenser units with a
vacuum cleaner or
compressed air.
CHECK
Power plug correctly connected
POWER button "OFF"
Blown fuse in mains plug
Fuse (supply) blown
Breaker on switch board tripped
Ambient temp. too high
(over 45°C) (Coolmobile : 40°C)
Filter blocked with dust
Dust in heat exchanger
Obstacle against inlet side
Ambient temp. too high
(over 45°C) (Coolmobile : 40°C)
ITEM
Diam. 125mm
REDUCES DUCT
43cm -> 30cm
56.001.599 - rev. 03 - 2020
Maintenance
Connect plug correctly
Press POWER button to "ON"
Replace fuse (MUST BE 13amp)
Exchange fuse in board
Check load capacity and reset
Use only below 45°C
Clean filter
Clean heat exchanger
Remove and allow 50cm. clearance
Use only below 45°C
Coolmobile 21-25
0,5m
✔
3m
OPTION
✔
✔
✔
OPTION
✔
English
1. Alter cleaning, completely
dry the inside of the unit by
operating on 'Fan Mode'
only tor 3 to 4 hours.
2. Turn "OFF" at control
panel, re move plug from
socket. Coil and store
cable neatly.
3. Keep machine suitably
covered to prevent damage
by damp, humidity and
dust.
SOLUTION
DRAWING
19