Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9. Canopy Assembly.
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket align
with slotted holes in canopy, and then lower
canopy and partially loosen these 2 screws. Remove
the other 2 screws/lock washers and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws/washers and secure all screws with
a Phillips screwdriver.
10. Glass Shade Installation.
Locate slots on glass shade and align with
nodules on underside of motor housing.
push up on glass shade and turn
(clockwise)
until it slides completely into place.
Pull down gently on glass shade to make sure
glass shade is secured completely.
11. Wall Control Operation.
The wall control is operational for fan
light
(dimmer).
0 - turns fan OFF
H - turns fan to HIGH speed
M - turns fan to MEDIUM speed
L2 - turns fan to MEDIUM LOW speed
L1 - turns fan to LOW speed
Gently
to the RIGHT
and
page 8
slotted
hole
hanging bracket
canopy
slots
glass shade
Publicidad
Capítulos
Tabla de contenido
