Canopy Assembly; Blade Assembly; Switch Housing Assembly - Craftmade MNR52OBG Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and push
up. Twist canopy to lock. Re-insert screw that was removed,
and then tighten both screws securely. Slide canopy cover up
to canopy, aligning rounded part of slotted holes in canopy
cover with screw heads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.

8. Blade Assembly.

BLADE OPTIONS: This fan can be used with TWO or
FOUR blades. If TWO-blade option is chosen, install
blade arm walls opposite each other using blade arm
screws and lock washers referred to in fourth
paragraph below.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and align
holes. Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten screws
securely with Phillips screwdriver. Repeat procedure
for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat procedure with
remaining blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.

9. Switch Housing Assembly.

Remove 3 screws from fitter plate on underside of motor.
Align holes in switch housing plate with holes in fitter
plate, allowing molex plugs from motor housing to
come through hole in middle of switch housing plate.
Re-insert screws that were just removed and secure all
screws.
Remove 3 screws from outer edge of switch housing
plate.
Align holes in switch housing cap with holes in switch
housing plate. Re-insert screws that were just removed
and use a Phillips screwdriver to secure all screws.
screw
blade arm
wall
(optional)
lock washers
page 7
hanging bracket
canopy
screw
canopy cover
motor
housing
blade attachment
screws and washers
blade arm
blade arm screws
motor housing
fitter
plate
molex
plugs
switch housing
plate
switch
housing cap
blade