Anomalies and repair
- Take the appliance to an authorised technical support
service if product is damaged or other problems arise.
Do not attempt to disassemble or repair the appliance
yourself as this may be dangerous.
- If any anomaly is detected, check the following table:
Anomalies
The unit does not work
The unit does not seem to
perform
The unit noise is high
Compressor does not work
Remote control does not
work
E1 on LCD
E2 on LCD
E3 on LCD
P2 on LCD
Specifications:
Voltage; 220-240V
Frequency: 50Hz
Dehumidifying capacity: 33.6L/j
Airflow: 453m3/h4
Exhaust pipe diameter: 1.5m/150mm
Working temperature: between 7-40ºC
Timer: 24 hours
Class I
Refrigerant gaz: R410A
Product size: 47*84*37cm
Product weight: 36kg
For EU product versions and/or in case that it is requested in your country:
Causes
No power supply
Water full indicator illuminate
Timer function is active
Room temperature too low or too high
Indirect sunlight
Window or doors open
Filter is very dirty
Air inlet or air outlet is blocked
Room temperature is lower than the setting
one
The unit is not put on a flat surface
Heat exceeded protection is active
The distance is too far
The batteries run out
Coil temperature is abnormal
Room temperature is abnormal
No refrigerant or there is very few refrigerant
The water tank is full
Solutions
Turn on the appliance
Drain out the inner stored water
Cancel timer function
Suggesting ambient temperature between 7-40ºC
Draw the curtains
Close windows and turn on another air conditioner
Clean or change the air filter
Clean out the stemming
Change the temperature setting
Put the unit on a flat and stable surface that can
support its weight
Re start the unit 3 minutes later till the temperature
low down
Let the remote control near the unit
Change the batteries
Check coil temperature sensor or relevant circuit
Contact the technical support
Check the room temperature sensor.
Contact the technical support
Check leakage, wielding, vacuum pump and contact
the technical support
Drain out the water