Operating Specifications - AGA marvel MP36BF2 Guia De Instalacion

Water Filter System Specification and Performance
Data Sheet
This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration of less
than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/53.* (100%
safety factors built-in for unmetered usage for health claims only.)
Contaminant Average
Reduction Influent
Chlorine Taste and 2.0 mg/L
Odor
Nominal Particulate 13,666,667
Class I, >0.5 to <
pts/mL
1.0 µm
Asbestos 96 MF/L
Atrazine 0.010 mg/L 0.009 mg/L + 10%
Cyst* 122,500
cysts/L
Lead @ pH 6.5 0.153 mg/L 0.15 mg/L + 10%
Lead @ pH 8.5 0.150 mg/L 0.15 mg/L + 10%
Lindane 0.002 mg/L 0.002 mg/L + 10%
Mercury @ pH 6.5 0.006 mg/L 0.006 mg/L + 10%
Mercury @ pH 8.5 0.006 mg/L 0.006 mg/L + 10%
Toxaphene 0.015 mg/L 0.015 mg/L + 10%
Turbidity 10.8 NTU
*Based on the use of Cryptosporidium parvum oocysts

Operating Specifications

Capacity:
Pressure Requirement:
Temperature:
Flow rate:
Check for compliance with the state and local laws and regulations.
Note: While the testing was performed under standard laboratory conditions, actual performance may vary.
Must be installed and operated in accordance with manufacturer's recommended procedures and guidelines.
Installation instructions, parts and service availability, and standard warranty are included with the product when
shipped. This drinking water system must be maintained according to manufacturer's instruction, including
replacement of filter cartridges.
Manufactured by: 3M Purification Inc.
NSF Specified
Challenge
Concentration
2.0 mg/L + 10%
At least 10,000
particles/mL
7 8
10 to 10 fibers/L;
fibers greater than
10µm in length
Minimum 50,000
cysts/L
11 + 1 NTU
Certified for up to 750 gallons (2,838 L); up to nine months
20 - 120 psi (1.4 - 8.2 bar)
33-100 o F (0.6 - 37.8
0.78 gpm (2.9 l/min.)
400 Research Parkway
Meriden, CT 06770
Average
Avg %
Product Water
Reduction
Concentrtation
97.5% 0.05 mg/L
98.9% 143,333 pts/mL
>99% <1 MF/L
89.3% 0.001 mg/L
99.99% 1 cyst/L
99.3% 0.001 mg/L
99.3% 0.001 mg/L
97.8% 0.00004 mg/L
95.0% 0.0003 mg/L
88% 0.0007 mg/L
93.2% 0.001 mg/L
98.7% 0.153 NTU
o C)
System tested and certified by NSF International
against Standard 42 for the reduction of chlorine taste
and odor, particulate Class I and Standard 53 for the
reduction of Lead, Lindane, Atrazine, Mercury,
Toxaphene, Cyst, Turbidity, and Abestos.
27
Max Permissible NSF
Product Water Reduction
Concentration Requirements
N/A > 50%
N/A > 85%
N/A > 99%
0.003 mg/L N/A
N/A > 99.95%
0.010 mg/L N/A
0.010 mg/L N/A
0.0002 mg/L N/A
0.002 mg/L N/A
0.002 mg/L N/A
0.003 mg/L N/A
0.5 NTU N/A
NSF Test
Report
J-00056501
J-00056506
J-00056511
J-00056512
J-00056513
J-00056515
J-00058784
J-00058969
J-00058785
J-00058783
J-00056531
J-00058972