Cub Cadet LS 25 CC Manual Del Operador página 8

10. Align the holes in the tongue with the holes in the tank
bracket and secure with the hardware just removed. See
Figure 3-2.
NOTE: The high pressure hose, which runs from the gear
pump to the bottom of the control valve, must be above
the tongue assembly.
11. The log splitter is shipped with the beam in a vertical
position. Remove any bolts or straps securing the end plate
to the bottom of the crate.
12. Pull out the vertical beam lock, rotate it back, and pivot the
beam to the horizontal position until it locks. Be sure to
avoid any possible pinch points. See Figure 3-3
Vertical Beam Lock
WARNING!
lowering the beam as it is heavy. Having a second
person assist with raising or lowering the beam is
recommended. Be sure to keep hands away from
any possible pinch points.
13. Remove the wood between the wedge and the end plate
by cutting the cable tie that secures it. Cut the strap near
the hose on the front of the cylinder that secures it to the
beam weld bracket. Be careful not to damage the hose.
8 S 2— A
ection SSembly
Figure 3-3
Take extra care when raising and
& S -U
et p
14. Disconnect the dislodger from the beam weld bracket by
removing the six hex screws. See Figure 3-4.
Hex Screws
Figure 3-4
15. Disconnect the log tray from the beam on the control valve
side by removing the two hex washer screws that secure it
to the beam weld brackets and the two hex washer screws
in the beam. See Figure 3-5.
Beam
Hex Washer
Screw
Figure 3-5
Hex Screws
Dislodger
Log Tray