Cleaning Upholstery - Hoover SteamVac FH50020RM Manual Del Proprietário

Cleaning upholstery

Be sure to check
the cleaning code
on your upholstery.
Use your HOOVER
SteamVac™ carpet
cleaner only on
upholstery marked
"W" or "W/S".
3.14
Manufacturers tag
3.15
3.16
1. Place handle in upright position.
2. Fill clean solution tank with HOOVER
Carpet/Upholstery Detergent according to
instructions on pages 10 and 11.
3. Attach tool to end of hose.
Do not point tools toward people or pets.
4. Dry hands and plug carpet cleaner into a
properly grounded outlet.
5. Turn carpet cleaner on. If necessary, refer
to "Before using tool" section to remove air
from system.
6. Gently press the tool onto the fabric. Press
the trigger and slowly pull the nozzle over
the fabric (Fig. 3.15).
7. Overlap strokes by 1/2 inch to help pre-
vent streaking.
Make additional strokes without pressing the
trigger to remove more moisture.
8. To clean in corners or creases, lift the tool
one-half inch from the fabric and press the
solution trigger.
9. Vacuum up the solution with the tool
without pressing the trigger.
10. For heavily soiled areas, it may be neces-
sary to repeat the cleaning process. Make
crisscrossing strokes to the original pattern;
overlap each pass (Fig. 3.16).
Make no more than 2 passes with the solu-
tion over any one area to prevent over-wet-
ting and damage to fabric.
If additional cleaning is necessary, wait until
the upholstery is completely dry before using
the tool again.
17 17
www.hoover.com www.hoover.com