Using The Invisible Wall; Placing The Batteries In The Invisible Wall; Positioning The Invisible Wall To Stop The Robot - Philips FC8932 Manual Del Usaurio

Using the invisible wall

Placing the batteries in the invisible wall

2
1

Positioning the invisible wall to stop the robot

The invisible wall operates on four AA batteries.
1 Push the two release tabs at the bottom of the back cover (1) and slide
the back cover upwards and off the invisible wall (2).
2 Take four new AA batteries from the pack and insert them into the
battery compartment of the invisible wall.
Note: Make sure the + and - poles of the batteries point in the right
direction.
3 Slide the back cover onto the invisible wall again.
You can use the invisible wall to prevent the robot from entering a room or
area that you want to keep it out of.
1 Place the unit at a point you do not want the robot to cross, e.g at an
open door to a room that is off-limits to the robot.
English
17