Troubleshooting; Accessories And Options; Disposal And Enviromental Protection; Tips And Advanced Use - Walimex Pro Speedlite LithiumPower 58 HSS4 Manual De Instrucciones

7. Troubleshooting

Problem Possible reason
Flash device is Powerpack exhausted
switched on, but has or defective (batteries)
no function
LC Display shows E0 Fault in the recharging
time
LC Display shows E2 System overheating
LC Display shows E3 Internal voltage inside
the flash is too high
8. Maintenance
8.1 Continuous inspection and maintenance of the device
Inspect all cables and plugs for damage.
WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
8.2 Cleaning
WARNUNG
Danger of electric shock
Just use the specified cleaning supplies. Do not bring the device into
contact with moisture or water.
Part of the Cleaning
device
Housing Use a microfiber cloth to remove light and stubborn dirt.
52
Remedy
Charge the powerpack/
replace the powerpack
(batteries)
Switch the flash off and
on. Try it again.
See item „Safety
function"
Contact our service
department

9. Accessories and options

You find optimal accessories for your device at our website.
10. Disposal and environmental protection
Please dispose of your device at your local disposal area at no charge.

11. Tips and advanced use

1. Indirect flashing
Indirect flashing means that you will take photos by reflecting the flash
from a wall or a ceiling, in order to soften the light.
2. Using reflex foil to take photos
Pull the reflex foil and the wide-angle diffusion disk simultaneously out of the
flash head and push the wide-angle diffusion disk back into the flash head.
In this case the flash will generate an attractive accent light in the eyes. The
effect is optimally achieved when the flash head is angled by 90°.
3. Using the wide-angle diffusion disk
Pull out the installed wide-angle diffusion disk to increase the illumination
angle of the flash.
This produces a softer and more natural flash light.
53