Reset Procedure; Register Your Product - U.S.Robotics MAXg USR5451 Guía Breve De Instalación

Idiomas disponibles

face. Click Finish to launch the Web User Interface in a new browser window and exit the

Detection Utility.

•

Click Start to begin the Setup Wizard procedure.

•

Follow the on-screen instructions in the Setup Wizard to configure the basic connection set-

tings of the Wireless MAXg Access Point. For more detailed Setup Wizard instructions, refer

to the Installation section of the User Guide on the Installation CD-ROM.

Congratulations!

You must configure your wireless network adapters to match the settings of the access point. You

should now be able to connect your wireless network adapters to the Wireless MAXg Access

Point. For troubleshooting and technical support information, refer to the Troubleshooting sec-

tion of this Guide or to the User Guide on the U.S. Robotics Installation CD-ROM.

Note: After you have completed the installation and configuration procedures, U.S. Robot-

ics recommends that you create a backup file of your settings in case you ever experience

some difficulties and want to restore your settings. Perform the following steps:

Launch a Web browser and access the Web User Interface.

You will be prompted to enter your user name and password. After entering your user name

and password, the Web User Interface will open.

Click the Device tab and then click Back Up in the Back Up Settings section. Refer to the

User Guide on the Installation CD-ROM for more information about this feature.

Reset Procedure

If you need to restore the factory default settings of the Wireless MAXg Access Point at any time,

press in and hold the RESET button for between five and ten seconds.

Warning: If you restore the factory default settings, the Wireless MAXg Access Point will

lose any custom settings.

You have finished installing your hardware and the necessary software.

Tabla de Contenido