Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Infrared Remote Control and I/O
Expansion Module
Installation, configuration and operation guide.
„
4 INSTALLATION OF THE ACCESSORY
The CFW100-IOADR is easily connected to the CFW100
frequency inverter by means of the plug-and-play
concept. The procedures below must be observed for
the proper installation and start-up:
1. With the inverter powered down, remove the front
cover from the inverter
2. Fit the accessory to be installed as shown in
A1 on page
3. Fit the cable with the IR receiver in "P1" on the
accessory as shown in
4. Power up the inverter.
5 CONFIGURATIONS
The CFW100-IOADR connections must be done to the
I/O expansion connector as per
The pins of the accessory connector are shown in
A3 on page
30.
6 | CFW100
(Figure A1 on page
29.
Figure A1 on page
29).
29.
Table 1 on page
Figure
7.
Figure
Publicidad
Tabla de contenido
