Electrical Connection - DeLonghi AN125HPEK Instrucciones De Uso

Transport, lling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
TO AVOID DAMAGE TO THE UNIT:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will brea down from lac of oil.

ELECTRICAL CONNECTION

This appliance is equipped with a 3 prong grounded plug. The
plug must be connected into an outlet that is properly installed
and grounded in the accordance with all local codes and ordi-
nances. Do not modify the plug provided with the appliance.
If it will not fit the outlet, have a proper outlet installed by a
qualified electrician or relocate the unit to a proper outlet. If the
household electrical supply does not meet the above specifica-
tions, or if you are not sure your home has an e ective electrical
ground, have a qualified electrician or your local electrical utility
company chec it and correct any problems.
SAFETY PLUG
The appliance is fitted with a safety plug to protect the power
cable.
If power is cut o , unplug from the outlet and ma e sure the
power cable is undamaged.
If the cable is damaged, call the service center immediately.
If power cuts o frequently and the power cable is undamaged,
contact a qualified electrician.
OPERATION OF THE SAFETY PLUG
If the safety device incorporated in the plug trips and cuts o
the power supply, chec that the power cable and plug are not
damaged.
If the power cable is undamaged, to restore operation press the
"RESET" button.
To verify correct operation of the plug, press the "TEST" button
periodically and ma e sure the appliance disconnects. If this is
not the case, contact the service center.
To restore operation, press the "RESET" button.
13