Operating From The Control Panel - DeLonghi AN125HPEK Instrucciones De Uso

OPERATING FROM THE CONTROL PANEL

TURNING THE APPLIANCE ON/OFF
Before plugging the appliance check the cap on back of
the unit are correctly inserted on drainage hose A10.
Plug the appliance into the electrical receptacle. Two lines ap-
pear on the display indicating that the appliance is in stand-by.
Press button (C1) to switch the appliance on.
When turned on, the air conditioner starts operating in the same
mode as when it was turned o .
To turn o the appliance, press the
appliance.
Note: Never switch o the appliance by unplugging it: always
press the button, wait a few minutes and then unplug. Do-
ing so, the appliance will run a chec of the operating conditions.
AIR CONDITIONING MODE
Ideal for hot muggy weather when you need to cool and dehu-
midify the room. To set this mode:
• Press repeatedly the MODE button (C2) until the
conditioning symbol is displayed: the display shows the
desired temperature.
• Press + (C6) or - (C3) buttons to adjust the desired tem-
perature.
• Select the fan speed by pressing the
You can choose:
Minimum speed: for silent operation.
Medium speed: reduces noise levels while main-
taining a comfortable temperature.
button, then unplug the
button (C5).
Maximum speed: to achieve the target tempera-
ture as rapidly as possible.
the appliance automatically selects the
most suitable fan speed in relation to the temperature set on the
digital display and current room temperature.
The most suitable indoor temperature for the room during the
summer varies from 75°F to 81°F (24 to 27°C). You are recom-
mended, however, not to set a temperature much below the out-
door temperature.
DEHUMIDIFYING MODE
Ideal to reduce room humidity (spring and autumn, damp
rooms, rainy periods, etc). In dehumidifying mode, the appli-
ance MUST be set-up in the same way as for air conditioning,
with the air exhaust hose (B2) attached to enable the moisture
to be discharged outside. To set this mode:
• Press repeatedly the MODE button until the dehumidifying
symbol is displayed.
FAN MODE
When using the appliance in this mode, the air exhaust hose
(B2) does not need to be connected.
To set this mode:
• Press repeatedly the MODE button until the fan symbol is
displayed.
• Select the fan speed by pressing the
You can choose:
Minimum speed: for silent operation.
Medium speed: reduces noise levels but still main-
tains a good level of comfort.
8
button (C5).