Example (1): Changing The Print Density - Oki LD670 Guía De Usuario

Example (1): Changing the Print Density

The procedure for this setting is as follows.
1. Before starting work for this setting, verify the following conditions of the
printer:
(1) The power is off.
(2) Roll paper is inserted in it.
(3) The cover is closed.
2. Enter special mode.
Turn on the power switch on the right side of the printer while
holding down the FEED switch on the left part of the Top cover.
Note: You must hold down the FEED switch until the printer starts
printing.
Note: If you have passed the item that you want to select, quickly press the
FEED switch repeatedly until you return to the first item.
The printer prints the following when it enters special mode:
Change from 130% to 100%
Test Print
End
Sample Print
Data Analysis
Cleaning
Sensor Adjustment
Setup
Test Print
Selection Item
Special Mode
Usage
Item Selection
Please push the feed switch short.
Item Decision
Please push the feed switch long.
81