Krups XP6010 Manual De Instrucciones página 17

KR_ESPRESSO_XP6010_NAFTA_NC00023130-04 31/05/12 10:07 Page19
Cleaning the adjustable spout and frothing spout
It is highy recommended that you clean the spout and its frothing nozzle after each time you froth milk.
Important
Ensure that the spout and its nozzle have cooled down before performing any
maintenance.
n Remove the frothing nozzle from the spout by turning it fully then pull the part to release (fig.10).
n Dip the frothing nozzle in very hot water to ensure that any milk residue is completely removed.
IMPORTANT
If any of the milk froth has dried up around the frothing nozzle, dip it in a container of water overnight
to soften the residue.
n Clean the outside of the plastic tube of the nozzle with hot water.
n If necessary, unblock the internal steam duct by inserting the needle supplied (t) into the nozzle hole and
running some hot water or steam through the plastic tube (See sections "Hot water function" page 15
or "Steam function" page 15).
n Ensure that all parts are completely dry.
n We also recommend that you use this needle to unblock the holes in the filters and the small hole at
the top of the detachable metal steam foam nozzle (fig 11).
n Carefully fit the special cappuccino nozzle by positioning the pins in the holes and rotating them anti-
clockwise until they lock into place (fig.12).
IMPORTANT
These operations are essential to prevent any risk of spreading micro bateria.
Cleaning the water tank
n Remove and clean the water tank every day. Rinse with clear water and re-position ensuring that it is
correctly lodged in its housing.
n If a layer of limescale should form on the tank walls, descale using a mixture of water and white vinegar.
Leave to rest for 1 hour.
n Wipe with a non-abrasive sponge and rinse thoroughly.
Cleaning the cup rest grill and drip tray
n Remove the drip tray by sliding it forwards (fig.13).
n Remove the cup rest grill by lifting upwards (fig.14).
n Clean the cup rest grill and drip tray with warm soapy water.
n Rinse and dry thoroughly.
n Clean the tray's stainless steel cover using a non-abrasive slightly damp cloth. Dry.
IMPORTANT
The water level indicator can be removed and re-attached using the clips.
Cleaning the appliance body, the cup warming plate
These parts of the appliance are cleaned using a non-abrasive and slightly wet cloth.
Important
Take care not to allow water on the control panel.
Any other servicing should be performed by an authorized service representative.
English
19