Tripp-Lite PDUMH30NET Serie Manual Del Propietário página 8

Features
Meter Select
LOAD (AMPS)
201105095 93-3048.indb 8
Digital Load Meter (Ammeter): The digital load meter
displays the load in amps. It may be set using the Meter
Select switch to display the PDU's total connected load
Bank 1
(all 16 outlets-both LEDs illuminated), or the load carried
Bank 2
by either the upper bank (Bank 1 LED illuminated) or
lower bank (Bank 2 LED illuminated) of 8 outlet
receptacles. For models with SNMP Network Card
installed, press and hold the switch to display the IP
address of the SNMP card in the PDU.
Output Circuit Breakers: Two circuit breakers (one per
outlet bank) protect connected equipment against
dangerous system overloads. If the total load on either of
the PDU's outlet banks exceeds 20 amps (PDUMH30NET
& PDUMH32HVNET) or 15 amps (PDUMH30HVNET), the
associated circuit breaker will trip, cutting power to the
entire outlet bank. Reduce the load on the outlet bank by
unplugging some equipment, then press the circuit
breaker in/set to the ON position to restore power.
Cord Retention Shelves (Optional): When installed on
the PDU, these shelves provide secure attachment points
for connected equipment power cords. Use the included
cable ties to secure cords to the shelf.
Mounting Brackets: These detachable brackets enable
the PDU to be installed in a 2U rackmount configuration
or an under-counter configuration.
Factory Port: The port is reserved for configuration by
factory authorized personnel only. Do not connect
anything to the port.
Ground Connection: Use this to connect any equipment
that requires a chassis ground.
PS/2 Port: Use this port to connect a Tripp Lite
ENVIROSENSE environmental sensor to provide remote
temperature/humidity monitoring and a dry contact
interface to control and monitor alarm, security and
telecom devices. Contact Tripp Lite Customer Support at
773.869.1234 for ordering information. Note: Do not
connect a keyboard or mouse to this port.
8
6/15/2011 3:07:30 PM