Lcd Symbols - Klein Tools IR2000 Manual De Instrucciones

temperature measurement
To take measurements with your IR2000, aim the instrument at the object
to be measured and pull the trigger. The unit has an auto off after releasing
the trigger of 60 seconds.
targeting
The IR2000 features a dual laser to assist in targeting the area to be
measured. The distance between the two lasers approximates the diameter
of the circular spot focused on by the infrared sensor. This area will
become larger as the target surface moves further away from gun (see
Distance to Spot Ratio for more information). The approximation will be
mostly accurate at a minimum distance of 12" from the IR2000.
selecting temperature scale
Press the Down Key while in display mode or any measurement mode
to alternate between Fahrenheit and Celsius. You can select either scale
during or after measurement, and when viewing any of the held values.
Lock mode (Auto-scan)
In lock mode, the IR2000 will take measurements continously without
holding down the trigger. The trigger can be held down to activate the laser,
but is not required.
Auto Hold
The IR2000 will hold the last temperature measured for 60 seconds after
the trigger is released. To recall this value or associated calculations press
the MODE key to activate the display and show the held temperature.
In probe mode, the unit will automatically power off after 12 minutes. In
auto-scan mode, the unit will automatically power off after 60 minutes.
toggling Laser & Backlight
To toggle the laser, hold down the trigger and press the Down Key. To
toggle the backlight, hold down the trigger and press the Up Key.
thermocouple probe mode
The IR2000 can measure the temperature from a K-Type thermocouple
probe. Press the mode key to enter Probe Mode. The measured
temperature will automatically be displayed. To see the minimum or
maximum temperature taken by the probe, press and hold the Down Button
or Up Button, respectively.
Laser is active
The backlight is on.
The last measurement taken is being shown.
The thermometer is currently taking measurements.
Auto-scan mode is active.
Celsius or Fahrenheit temperature scale.
Battery is OK.
Battery is low and should be replaced.
Battery is exhausted. Replacement necessary before use.
GRAPHICS DRAWING NAME: IR2000-139672TART
GRAPHICS PART NUMBER:
PACKAGING DWG. REF.: NA Revision: A
OpErAtiNG iNstructiONs

LcD symBOLs

139672T
ECN NUMBER.: 10943