Telephone Operation - Federal Signal AR2000-M Manual De Instalación Y Mantenimiento

CH A
PHONE
AUX SPEAKER
MICROPHONE
CH B
Each preset can be manually activated locally with
its associated push button switch on the front panel or
with a contact closure at the associated preset control
input on the back panel. Whenever a preset is activated,
either locally or remotely, its associated front panel push
button LED illuminates to indicate that the preset has
been activated. The LED remains lit until the preset is
deactivated or the remote contact closure is removed. As
an added feature, when a preset is remotely activated,
the associated LED illuminates and flashes until the
remote contact closure is removed. All AR2000-M
controls are located on the front panel except gain
adjustments which are made on the back panel during
installation.
Operation (normal mode)
Pressing the Channel A or Channel B button will
immediately switch the input to that channel; the speaker
indicator lights will indicate what speakers are connected.
Pushing a speaker button will turn that speaker on or
off; pushing a preset button will select speakers per
that preset, and may also select Channel A or B (if that
preset was configured for a specific channel). Keying the
microphone while in this mode will cause the microphone
signal to be sent to the selected speakers; releasing
the microphone will allow Channel A or B operation to
resume.
Keying the Microphone button will allow the user to
direct audio to specific zones (default is All-Call). The user
may select zones using either individual speaker or preset
buttons; Channel A or B operation will not be interrupted
until the microphone is actually keyed. Releasing
the microphone will allow Channel A or B to resume
operation on its selected speakers.
AR2000-Z
ALL CALL
FEDERAL
SIGNAL
CORPORATION
R UNIVERSITY PARK, IL U.S.A.
ALL CANCEL
AR2000-M
FEDERAL
SIGNAL
CORPORATION
R UNIVERSITY PARK, IL U.S.A.
PRESET 1 PRESET 2 PRESET 3 PRESET 4 PRESET 5
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5
Figure 1-1.
Pressing the All Call button (whether the unit is in
Microphone mode or Channel A/B mode) will cause all
zones to be selected. Pressing any individual zone when All
Call is lit, however, will cancel all the zones except that one.
Pressing All Call will perform the following function:
If all of the zones are not selected, "All Call" will
select all 64 zones. Otherwise, pressing "All Call" will
cancel all of the zones.

Telephone operation

When the line attached to the Router is called,
the router will answer with the Message "ENTER
PASSWORD". The caller is required to enter their 8 digit
password. The caller is given 2 chances to enter the
correct password.
If the correct password is not entered, the caller
hears the message "GOODBYE" and the system hangs
up the phone line.
If the correct password is entered the caller will
hear the message "PRESS 9 KEY TO CHANGE THE
PASSWORD OR 6 KEY TO RECORD A MESSAGE".
If the caller presses the 9 key, the message "ENTER
NEW PASSWORD" will inform the caller to enter a new
password. The same new password must be entered
twice. Otherwise, the caller will hear the message
"PASSWORD NOT CHANGED" then the message
"GOODBYE" and the system hangs up the phone line. If
the new password is successfully entered twice, the caller
will hear the message "PASSWORD CHANGED" then
the message "GOODBYE" and the system hangs up the
phone line.
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5
Figure 1-2.
-2-
PRESET 6 PRESET 7 PRESET 8
ALARM
ZONE 6 ZONE 7 ZONE 8
POWER
ZONE 6 ZONE 7 ZONE 8
POWER
290A4120-01
290A4120-02