Cooking zone
timer
Timer (generic)
Defrost function
Heating function
12
The timer allows a specific cooking area to be switched off when the set time expires.
The cooking areas can be programmed individually because each one has its own timer.
To enable: With the cooking area switched on, press the corresponding symbol
timer controls for that area.
The 3 digits indicate "0 0 0". Press "+" or "-" to set the timer countdown.
To confirm the set time, do not touch anything for 10 seconds.
When the countdown has finished, the digits are reset and an audible signal is emitted. The func-
tion can be interrupted by pressing any key.
If the timer is enabled for more than one cooking area, the 3 digits will always show whichever timer
is about to finish first.
To disable: with the cooking area switched on, press the corresponding symbol
timer controls for that area.
Set the three digits to "0 0 0" using "+" or "-".
Timer with alarm for generic use.
To enable: switch on the hob making sure there are no pans or active cooking areas.
The 3 digits to control the timer show "- - -".
Press the digit to access the timer menu and display "0 0 0".
Press "+" or "-" to set the timer countdown.
To confirm the set time, do not touch anything for 10 seconds.
When the countdown has finished, the digits are reset and an audible signal is emitted. The func-
tion can be interrupted by pressing any key.
Repeat the steps described to change the countdown value.
To disable: switch on the hob making sure there are no pans or active cooking areas.
Press the digit to access the timer menu and use "+" and "-" to set the display to "0 0 0".
To enable: select one of the 4 cooking areas and press
The digit of the selected area shows
To disable: press
or press
This function is used to heat a pan to the maximum power before continuing to cook at a selected
level. The time interval for which the cooking area is held at maximum power depends on the final
cooking level that has been set. See the table:
Power level
1
2
3
4
5
6
7
8
9
P
To enable, with a pan on the bob and the cooking area selected, press and hold the selected value
(from 1 to 8) on the power bar for 3 seconds. The display of the corresponding cooking area indic-
ates "A".
The cooking level can be increased, but the function is disabled if it is decreased.
It can also be disabled by touching and holding the cooking area in question for 3 seconds.
Hours - Tenths - Minutes
Hours - Tenths - Minutes
.
.
.
Timer (seconds)
48
144
230
312
408
120
168
216
Not available
Not available
to access the
to access the