RISCO Group RVCM11H Guia De Instalacion página 12

NOTE – If your network is password protected, a password must be entered into
the displayed password screen.
11. Click OK to establish the wireless connection (Refer to Connecting to a
Wireless Network using the RISCO Cloud).
IMPORTANT – Once a wireless connection has been established, don't forget to
disconnect the IP camera Ethernet cable from the router.
12. Once the "camera is ready for use" message is displayed, click OK. The
defined IP camera is displayed in the IP Cameras page.
Figure 11 IP Camera List
NOTE – You also have the option to edit
Defining Camera Trigger Settings
Any event from the following list can be defined to trigger an alarm.
Fire Alarm
Full Arm
Tamper
Environ. Alarm
Alarm
Partition Events
Panic Alarm
Part Arm
24 HR-X Alarm
No Motion Alarm
Detector Events
Zone Bypassed
or delete the selected IP camera.
Medical Alarm
Disarmed
Water Alarm
Exit Alarm
Zone Un-bypassed
12
Alarm
Duress
Gas Alarm
Low Temperature
Zone Tamper