Trolling Motor Mount Orientation; Installing The Transducer On A Trolling Motor Shaft; Trolling Motor Shaft Orientation - Garmin PANOPTIX LIVESCOPE Instrucciones De Instalación

2
Secure the hose clamp around the trolling motor
NOTE: Do not rotate the transducer.
3
Secure the transducer cable to the motor shaft or other secure location.
4
Route the transducer cable to the installation location of the sonar module
while taking these precautions.
• You should not route the cable close to electrical wires or other sources
of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is
deployed or stowed.
5
Position the transducer to your desired angle (Trolling Motor Mount
Orientation, page 3).

Trolling Motor Mount Orientation

The orientation depends on which side of the trolling motor you have mounted
the transducer on, and your desired field of view.
Starboard side, forward view
Starboard side, downward view
Port side, forward view
Port side, downward view

Installing the Transducer on a Trolling Motor Shaft

Trolling Motor Shaft Bracket Orientation
The trolling motor shaft bracket features an 8-degree cant to reduce the effects
of the trolling motor barrel interference with the transducer beam. You must
orient the arrow and the narrow end of the angle
attach the bracket to the trolling motor shaft.
Installation Instructions
Assembling the Trolling Motor Shaft Mount Hardware
With the trolling motor bracket oriented correctly (Trolling Motor Shaft
Bracket Orientation, page 3), use the included hex wrench to attach the
transducer
flat washer
NOTE: The recommended torque applied to the shoulder screw is 2.5 lb-ft.
(3.4 N-m).
.
Installing the Transducer on the Trolling Motor Shaft
You must secure the transducer cable to the shaft or other secure location
during installation. Damage to the transducer cable wire or the cable jacket
can cause transducer failure.
You should mount the transducer as far from the motor as possible.
You should use the included rubber insert on a 25 mm (1 in.) trolling motor
shaft.
1
Using the included hex wrench, insert the M6 screws
shaft trolling bracket
motor shaft.
2
Secure the transducer cable to the motor shaft or other secure location.
3
Route the transducer cable to the installation location of the sonar module
while taking these precautions.
• You should not route the cable close to electrical wires or other sources
of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is
deployed or stowed.
4
Position the transducer to your desired angle (Trolling Motor Shaft
Orientation, page 3).
to the top when you

Trolling Motor Shaft Orientation

The angle of installation depends on the side of the trolling motor shaft you
mount the bracket on, and your desired field of view.
to the trolling shaft bracket with the shoulder screw
, and rubber washer .
NOTICE
to the transducer bracket
,
and attach the
around the trolling
3