Mounting - Dantherm HCC 2 ALU Manual De Servicio

Installation : Mounting

Mounting

Multi purpose The enclosed bracket can and should be used, both for wall and for ceiling installation. The
mounting bracket bracket will automatically tilt the unit 1° towards the condensate drain, when mounted un-
derneath the ceiling.
Wall mounting
Please follow this procedure to install the HCC 2 vertical onto a wall.
Step Action
1
2
3
4
5
6
Fig. 16
Drill two holes for the
bracket, fulfilling all dimen-
sion requirements shown in
the section "General location
requirements" on page 12.
Mount the bracket with ap-
propriate screws
Lift the unit onto the bracket
Drill and mount two appro-
priate screws in the lower
unit bracket
Connect ducts according il-
lustration at page 15
IMPORTANT: the T1 and T4
outside air ducts, must AL-
WAYS be routed to the duct
connections in the bottom
Connect ducts and drain
hose.
Illustration
1 2
1 4
Fig. 17
1 1
17